Caster Installation; Carton Contents - Craftsman 31016 Manual De Usuario

HarDWare
tooLs requireD:
3/8" wrench
Flat-tip Screwdriver
Hardware included:
1/4-20 Hex Nut (Qty: 16)
1/4-20 x .438-in HW Screw (Qty: 16)

cartoN coNteNts

cabinet:
Literature
Hardware bag
Caster pack
Caster pack

caster iNstaLLatioN

items Needed:
1/4 - 20 x .438-in (Qty: 16)
1/4 - 20 Nut (Qty: 16)
Screwdriver
3/8-in Wrench
process:
• Remove bottom drawers. (See Operation Section, Part
B.)
• Lay the cabinet on its back. Use packaging material to
protect the finish.
• Mount both swivel casters on the same side of the unit
as the side handle.
• Attach the casters using (4) 1/4 - 20 x .438-in screws and
(4) 1/4 - 20 nuts per caster.
• Wrench tighten all screws. It is recommended not to
exceed 80 inch pounds of torque.
• Return the unit to its upright position.
• Reinstall bottom drawers.
Nut
Note: Not all operation instructions will relate to your model.
tHe LocKBar for tHe roLL-aWay is storeD iN a
sLot iN tHe top froNt corNer of tHe uNit.
to LocK roLL-aWay
process:
▪ Insert the straight end of the lockbar into the slot in the
base.
▪ Move the lockbar toward the unit until the bent end fits
into the slot near the lock.
▪ Lock with the key.
NOTE: If your unit is equipped with a storage compartment
with a panel at the bottom, pull panel out, lift up and push
panel back into unit to gain access to compartment.
2
assemBLy
Screw
operatioN