Teamtex FERRARI V5807A Manual De Instrucciones página 17

back through the desired slots in the
cover, liner and seat. Make sure you
thread the keeper back into the slot
below.
Feed the shoulder strap back through
the same slot and re-attach onto the
metal yoke.
Then repeat the procedures for the
shoulder strap and restraint on the
other side.
Make sure there are no kinks or twists in
the straps.
Replace cover on seat shell.
7 Reclining your child seat
8 User guide
It is important to refer the safety advices.
Read these instructions carefully and
1 - This is a "Universal" Child restraint. It is approved to Regulation N° 44 series
of amendments, for general use in vehicles and it will fit most, but not all, car
seats.
2 - A correct fit is likely if the vehicle manufacturer has declared in the vehi-
cle handbook that the vehicle is capable of accepting a "Universal" child
restraint for this age group.
3 - This child restraint has been classified as "Universal" under more stringent
conditions than those which applied to earlier designs wich do not carry this
notice.
4 - Only suitable if the vehicle is fitted with a type approved 3 point static or
retractor safety belt in compliance with standard UN/ECE 16 or other equi-
valent standards.
5 - If in doubt, consult either the child restraint manufacturer or the retailer.
retain this user guide for future reference.
An incorrect installation could be dan-
gerous.
9 Care of your product
The fabric cover can be removed from
the seat. In case of light soiling, sponge
with a mild detergent and warm water,
or hand-wash at 30° . Do not use chemi-
cal cleaners, do not machine-wash, do
not tumble-dry, do not iron.
NOTICE
16