Glacier bay 461-5001 Guía De Uso Y Mantenimiento página 6

Installation (continued)
3
Installing the hot and cold
valves
□
From underneath the deck, insert the cold end
valve (M) with the rubber washer (N), metal
washer (O), and mounting nut (P) through the
hole on the right (cold) side.
□
From above, thread the ange (K) onto the
valve stem.
□
Tighten the mounting nut (P) using a basin
wrench, so that the ange (K) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve
(L) on the left (hot) side.
L
K
M
N
O
P
4
Installing the handle
assemblies
□
Thread the handle anges (J) onto the valve
stems.
□
Place the inverters (I) onto the valve stems (1),
and secure them with the screws (H). Use a
Phillips screwdriver to tighten the screws (H).
□
Place the handles (E) onto the inverters (I), and
tighten the set screws (F) with the Hex wrench
(AA). Insert the indexes (G).
6
E
G
F
H
I
J
1