Before You Start - Team kalorik TKG HC 1002 R Manual De Instrucciones

Fax +32 2 359 95 50
Do not use the appliance if the adapter or its cord is damaged. The adapter is not
repairable, it has to be returned to the seller during guarantee period or thrown away
when the guarantee has expired. In that case it has to be replaced by an identical
model.
Never use the appliance with its adapter outside and always place it in a dry
environment.
When you decide to throw away the appliance, make sure to remove the battery and to
dispose of it in an ecological manner. For more information contact your town authorities.
BE CAREFUL NOT TO TOUCH THE ACCUMULATOR OR THE LEAKING LIQUID.
(*) Competent qualified electrician: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
CONNECTING
•
The charging base can be connected to any voltage outlet - even to shaver sockets -
between 230-240 volts ac (-).
•
Place the rechargeable hair clipper, facing the front onto the charging base.
•
The red charge indicator will light up, when the power unit is inserted on the plugged-in
charging base.
•
The hair clipper may warm up somewhat during recharging. This has no significance on
the unit's operation. Overcharging is impossible.
•
To maintain the hair clipper's full performance, it should always be stored on the charging
base after use.
PRESERVING THE RECHARGEABLE BATTERY
To maximise the capacity and life of the rechargeable battery, it should be fully charged for 16
hours before the first use and then fully discharged by using. Then recharge to full capacity (6
hours). This discharging/charging procedure should be done every six months.

BEFORE YOU START

•
Make sure that your clipper is clean, properly oiled and in perfect working condition.
Caution: if the blade is not oiled correctly, the appliance will not work properly.
•
Place a towel around the neck of the person whose hair is to be cut to prevent hair from
falling inside the collar.
•
Have the person sit on a chair so that his/her head is at your eye's level.
•
Comb the hair thoroughly and hold the clipper in a relaxed, comfortable grip. This will help
you maintain an accurate cutting control.
OIL (see page 2: A)
To maintain your clipper in peak condition, the blades should be oiled every few haircuts. Do
not use hair oil, grease or oil mixed with kerosene or any solvent, as the solvent will evaporate
and leave the thick oil which may slow down the blades' motion.
CUTTING HAIR WITH COMB ATTACHMENT (SEE PAGE 2: B)
To attach the comb, hold it with teeth up and snap the comb attachment firmly to the bottom
of the clipper blade:
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
9
Assembly page 9/56
TKG HC 1002 R - 130306