Safety Instructions - JBM 60034 Manual De Instrucciones

REF. 60034
EN
INSTRUCTION MANUAL
PRODUCT'S PRESENTATION
This tool is designed to tighten and loose screws, as well as to
drill in wood, metal, ceramic and plastic.
It is equipped with a LED light for an enhanced visibility, a va-
riable speed switch, a forward/reverse selector which allows to
lock off the trigger and prevent an accidental starting, and an
ergonomic handle for an improved grip and precision.
It features 5 different gears, 3 for tightening and 2 for loose-
ning, allowing a speed adjustment according to operation to be
carried out.

SAFETY INSTRUCTIONS

WARNING! Read all safety warnings and all instructions.
Failure to follow the warnings and instructions listed below may
result in electric shock, fire and/or serious injury.
• Check for breakage of parts, damage to switches and any
other conditions that may affect its operation.
• Do not operate the tool in the presence of flammable li-
quids, gases or dust.
• Dress properly. Do not wear loose clothing or jewelry and
tighten long hair.
• Avoid an accidental starting. Disconnect the battery from
the tool and place the switch in the locked or off position
before making any adjustments, changing accessories, or
storing the tool.
• Keep the tool and its handle dry, clean and free from oil
and grease.
• Always wear eye and respiratory protection.
• Hold the tool by the insulated grip surface when performing
an operation where the tool may come in contact with the
hidden wiring. Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the operator.
• Make sure all keys and adjusting wrenches are removed
from the tool before switching it on to avoid them to fly
away at high velocity.
OPERATION
Inserting the bits
1. Holding the keyless chuck firmly, turn it anticlockwise until
the drilling bit can be inserted.
2. Holding the keyless chuck firmly, turn it clockwise to lock
the bit in position.
Switching On/Off
To turn it on, slowly depress the trigger switch.
To turn it off, fully release the trigger switch.
NOTE! The trigger switch can be used as a variable speed con-
trol mechanism. The higher the pressure on the trigger switch,
the higher will be the rotational speed, while light pressure on
the trigger results in a low rotational speed.
LED Work light
When the trigger switch is partially or fully depressed, the LED
work light will be on to illuminate the direct working area of ope-
ration. When you release the trigger, the light will keep working
during 3-5s before turning off.
Rotation selection
To change the rotation direction, you can use the forward/re-
verse selector:
• To set a right rotation, used for drilling and driving in
screws, push the switch to the left side of the tool.
• To set a left rotation, used for loosening or unscrewing
screws, push the switch to the right side of the tool.
NOTE! The forward/reverse selector in its central position locks
the trigger switch and prevents an accidental starting of the tool
while not in use.
Rotational speed functions and adjustment
While tightening and loosening screws, there are 5 different
gears or speeds, which can be changed with the adjustment
button on the selector, and indicated through the four LED light
bars:
For tensioning/tightening:
1. Make sure the forward/reverse selector is set the towards
the left side of the tool.
2. Press the button to choose the desired gear among the
3 showed below, from a lower to a higher speed respec-
tively:
Gear 1
· 5 ·
Gear 2 Gear 3