Tabla de contenido
Publicidad
Attention
Before you unpack the hard disk drive, be sure to read "Handling
the drive" on page 1-1.
i. Attach the side rubbers to the new hard disk drive.
j. Insert the hard disk drive with the attached side rubbers into the hard
disk drive bay; then firmly install them and replace the cover.
k. Reinstall the screw.
Note: You can replace the screw with a security screw to prevent the
hard disk drive from being easily removed. The security screw
may not be included in your ship group. However, you can
purchase screws directly from NABS at www.nabsnet.com.
l. Reinstall the battery.
m. Connect the ac adapter and cables to the computer.
3. Insert the drive into the adapter at an angle.
4. Slide the drive into the connector until it locks into place.
5. Lower the adapter retaining latch until it snaps closed.
1-4
Serial Hard Drive Bay Adapter User's Guide
Publicidad
Tabla de contenido
