CHIEF iC Serie Manual De Instrucciones página 15

Installation Instructions
4
1
3d
Knobs to outside
of brackets
Knobs
2
3e
Switching Interface Brackets (Optional)
If an installation situation makes adjusting the location of interface
brackets necessary, there are several options.
1. The wall brackets may be adjusted side to side at the point of
attachment.
2. The location of the left and right interface brackets may be
switched, with the knobs on the iCMPTM2 interface brackets
facing the inside of the mount.
3. If necessary, the tilt interface bracket knobs may be switched
to allow the interface brackets to be reversed.
a. Remove display from mount.
b. Remove interface brackets from display.
c. Hold the right interface bracket horizontally, tightly gripping
it so that spacers do not move.
d. Remove the knob, washer and screw.
e. Replace the knob, washer and screw in the opposite order,
with the knob on the inside of the bracket.
f. Switch the right interface bracket to the left side of the wall
mount.
g. Repeat Steps 3c through 3f with the left interface bracket.
Tilting the Interface Brackets (iCMPTM2 only)
The brackets may be tilted by loosening the knob on the brackets,
tilting to desired location, and tightening knob on the brackets.
iCMPFM2 / iCMPTM2
15