CHIEF iC Serie Manual De Instrucciones página 14

iCXPFM2 / iCXPTM2
2b
(J1) x 4
3 7
4 8
(J3) x 4
3
Center of bracket
14
1. Using a level, mark the wall through both upper mounting
slots.
2. Drill one 25/64" (10mm) pilot hole at each marking.
5
1
3. Install an anchor (J1) into each pilot hole using a hammer.
x4
4. Use two 5/16 x 2-1/2" lag bolts (J3) and two 5/16" flat washers
(J2) to attach top of mount to anchors in wall.
2 6
5. Mark the attachment points for the lower mounting slots.
6. Drill one 25/64" (10mm) pilot hole at each marking for lower
mounting holes.
7. Install an anchor (J1) into each pilot hole using a hammer.
8. Use two 5/16 x 2-1/2" lag bolts (J3) and two 5/16" flat washers
(J2) to attach the mount to the wall through the lower
mounting holes.
9. Slide rails to approximate center of screen location.
(J2) x 4
Attaching Interface Brackets to TV
1. Align the center of the bracket with center of screen.
NOTE:
WARNING:
DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! Using screws of improper size
may damage your display. Properly sized screws will easily and
completely thread into display mounting holes. If spacers are
required, be sure to use longer screws of the same diameter.
2. Select correct screws, spacers (if necessary) and universal
washers from the hardware bag (H) and attach brackets to
back of screen.
The diamond-shape hole in the bracket corresponds to
the center of the mount.
IMPROPER INSTALLATION CAN LEAD TO
Installation Instructions