Brandson Equipment 301480 Manual Del Usuario página 21

5. Assembly
Take the fan out of the package and check the device as well as the scope of deliv-
ery mentioned in the table above. Please contact the vendor if any part is missing
or has been damaged. Now place the rear protective cage (5) on the fan unit. Make
sure that the handle is facing up.
Tighten the protective cage firmly using the mounting nut (4).
Then insert the rotor blade (3) onto the rotor axis (6) and fasten it using the
appropriate mounting nut (2).
Caution: The mounting nut needs to be tightened counter-clockwise.
Mount the front protective cage (1) onto the rear protective cage. A hole is pro-
vided for a locking screw at the bottom of the two protective cages.
Insert the locking screw (15) through the hole of the front and rear guards and fas-
ten it using the locking nut. Then connect the four mounting brackets to the side.
Take the pedestal (13), place the guard (12) on it and connect the outer pipe (11)
to the pedestal.
Fix the outer pipe (11) to the pedestal (13) from below using the fastening screw
(14).
Then slide the height adjustment mechanism (10) from above onto the inner pipe
(9).
Finally, the fan and pedestal have to be put together.
Attach the fan to the pedestal and secure it using the locking screw (8).
21
English