Nikken PiMag MICROJET Manual Del Usuario página 3

A. Plastic end covers (to be discarded)
B. Plumbing tape
C. Rubber washers
D. MicroJet bracket mounting
E. Bracket mounting pipe stub
F. MicroJet flexible hose
G. Hose hex nut
H. MicroJet hand unit (with filter cartridge inside)
Handheld model
I. Hose round nut
J. Bracket hose retainer
1. Remove any showerhead that is already installed.
2. Take the MicroJet unit out of its packaging and
remove the three protective plastic covers (A) from
both hose connector nuts (G, I) and the end of the
MicroJet hand unit (H).
3. Wrap plumbing tape (B) around the screw threads
of your shower plumbing pipe. Keep the tape
surface flat and wrap in a clockwise direction.
4. Make sure that the rubber washer (C) is in place
inside the connector in the top of the MicroJet
bracket mounting (D). Attach this bracket to your
plumbing pipe.
5. Wrap plumbing tape around the screw threads on
the pipe stub (E) on the side of the MicroJet
bracket mounting (D). Keep the tape surface flat
and wrap in a clockwise direction. Insert a rubber
washer (C) in the end of the MicroJet flexible hose
(F) that has the hexagonal (six-sided) nut (G).
Attach this end of the flexible hose to the bracket
pipe stub (E).