Publicidad
7.
Remote Control
Battery
Refer to illustration [B1] on page 3 of this manual.
The remote control uses 1 battery type 3 V lithium CR2025
(included). Remove the tag from the battery compartment before
use.
1.
To (re)place a battery, press on the side of the battery cover
and pull to slide open.
2.
Insert the battery with the correct polarity and close the battery
compartment by pushing back into the housing of the remote
control until it snaps into place.
Operation
1.
Aim the remote control towards the IR LED of the controller to
control the output of the LED strip.
2.
Switch on the LED strip with the ON button on the remote
control. To switch it off again, press the OFF button.
3.
Refer to chapter 5. Overview for more information about
operating the remote control.
8.
Technical Specifications
IP rating
coating
colour
viewing angle
LED spacing
power supply
dimensions
weight
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual,
please visit our website www.velleman.eu. The information in
this manual is subject to change without prior notice.
V. 02 – 22/10/2015
LEDS12CWW
IP61
silicone
warm white/cold white
120°
16,5 mm
12 VDC 24 W (adapter incl.)
5 m x 8 mm
420 g
7
©Velleman nv
Publicidad
