Volume/Tone Push Button - PSC Magellan 2200VS Guía De Referencia Rápida

Volume/Tone Push Button

The Volume/Tone Push Button also performs multiple functions depending upon
the duration of time it is pressed:
NOTE
Table 1-1. Volume/Tone Push Button Functions
PRESS
DURATION
Momentary (when
scanner is asleep)
Momentary (when
scanner is awake)
Hold, then release
when the beeper
sounds
4 Seconds
8 Seconds
a. By standard default, this function is normally disabled to prevent accidental activation by users.
b. Users should not perform scanner resets except under the direction of trained systems support person-
nel.
Quick Reference Guide
Volume changes made using the Volume/Tone Push Button are lost
when the scanner is powered-down and are reset to the configured set-
ting. If you wish to permanently change the volume, use the special
programming labels in the Product Reference Guide.
FUNCTION
Wakes scanner from Sleep
Mode
Increments volume
Increments tone
Scanner Diagnostics Mode
b
Resets Scanner
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase speaker
volume. When the loudest volume is reached, a
repeated press of the push button cycles volume back
to the lowest setting, then volume increases on subse-
quent press(es). Four volume levels are available.
Press the push button for approximately 2 seconds,
then release. Each time this is done, the beeper will
sound at one of three tones. Stop when the desired
tone (high, medium or low) is sounded.
This mode allows system support personnel to trouble-
shoot problems with the scanner and is used to deter-
a
mine if it can read bar codes. Press the button for eight
seconds or cycle power to exit Scanner Diagnostics
Mode and reset the scanner.
Only system support personnel should perform a reset.
COMMENT
3