Package Contents; Description (Fig. A); Electrical Safety - DeWalt DW620 Manual De Instrucciones

Follow the instructions for maintenance and
changing accessories. Inspect the tool cords at
regular intervals and, if damaged, have them
repaired by an authorized D
Inspect the extension cords periodically and
replace them if damaged. Keep all controls dry,
clean and free from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function. Check for misalignment and
seizure of moving parts, breakage of parts and any
other conditions that may affect its operation. Have
damaged guards or other defective parts repaired
or replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety rules for cutters
• Always use cutters with a shank diameter
corresponding to the size of the collet installed in
your tool.
• Always use cutters suitable for a speed of
-1
30.000 min and marked accordingly.
• Never use cutters with a diameter exceeding the
maximum diameter indicated in the technical data.

Package contents

The package contains:
1 Router
1 Parallel fence with fine adjustment and guide rods
1 Collet 8 mm (GB: 1/4")
1 Guide bush 24 mm
1 Wrench # 17
1 Dust extraction plug
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
18
WALT repair agent.
E

Description (fig. A)

Your D WALT high performance router
E
DW620/DW621 has been designed for professional
heavy duty routing of wood, wood products and
plastics.
1 Lock-on/lock-off switch
2 Spindle lock
3 Collet nut
4 Parallel fence locking bolt
5 Guide rods for parallel fence
6 Dust extraction outlet in parallel fence
7 Fine adjuster for parallel fence
8 Parallel fence
9 Locking bolt
10 Router base
11 Finger guard
12 Revolver depth stop
13 Depth stop
14 Depth stop locking bolt
15 Plunge limiter
16 Quick adjuster for depth stop
17 Fine adjuster for depth stop
18 Dust extraction adaptor
19 Speed control dial (DW621)
20 End lock

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
E N G L I S H
en - 3