TECO TK 2800 Manual De Instrucciones página 12

TANK
5.2 INSTALLATION AND FUNCTIONING OF THE DEVICE
1) Do not install and do not try to repair the product if it was damaged during transport.
2) Do not connect the power cord to the power supply, unless specifi cally required.
3) In order to ensure the correct working of the device in safe conditions, it is absolutely forbidden to expose the
product to atmospheric agents and to direct heat sources. The temperature of the installation environment
has to be between 5 °C and 38 °C (41 °F – 100 °F).
4) Choose the place foreseen for the installation of the device. It must have the following features:
- It must have openings that allow change of air with the outside.
- The air change must be such to dissipate the heat of the device.
- Make sure that the room temperature does not exceed 38 °C (100 °F) during operation.
5) Place the device by taking into consideration the minimum recommended distances to allow visibility:
Air outlet side (Ref. B)
Filter side (Ref. A)
6) Lay the tubes as follows:
Insert the fi tting (supplied in the package, including gasket and
ring) inside the pipe, screw clockwise the fi tting orienting it as
needed and tighten fi rmly.
7) In connecting the pipes, check that the pipe coming from the
pump and/or from the fi lter group (not supplied as standard)
is connected in the position indicated with INLET (Ref. C) and
that the return pipe to the aquarium is connected in the posi-
tion indicated with OUTLET (Ref. D)
8) Install the unit in the chosen place allowing the visibility of the
equipment.
9) Start the pump and make sure that the water circulates regu-
larly within the circuit without any leaks. In case of abnormali-
ties of the hydraulic circuit or leaks thereof, inspect the con-
nections.
10) WARNING: Make sure that the water that reaches
the device is fi ltered.
11) Make sure that the electrical power supply requirements cor-
respond to those shown on the technical data plate, applied on
the rear of the device.
12) When the aquarium pump is functioning, connect the cable
power supply to the power socket with the plug. Then, the dis-
play will show OFF.
Pressing the power button (Ref. A7) for at least 3 seconds,
your device will start working, on the display it is indicated the
actual water temperature. To display the temperature to be reached press the SET button (Ref.A8) to return
to the water temperature press the SET button (Ref.A8) or wait for 5 seconds.
13) WARNING: A 2-minutes delay was added to prevent compressor failure at the fi rst start.
14) To stop the device, press the power button (Ref. A7) for at least 3 seconds, the display will show OFF.
WARNING: To prevent damages, the unit cannot operate without water fl ow (pump off ).
10
C H I L L E R L I N E
>500 mm – 19.7 in
>300 mm – 11.8 in
Tab. 5-1
EN
C
D
E
F
A
B