Technical Parameters - power up 79942 Manual De Instrucciones

PROPERTIES OF THE DEVICE
Submersible pumps are household appliances. They are designed to pump clean and slightly contaminated water from reservoirs
in an intermittent working cycle. Acceptable time of continuous operation is 30 minutes, and then work must be interrupted for
at least 15 minutes. By no means is it permitted to pump other liquids than water, such as oils, gasoline, solvents, acids, bases,
organic substances, fats, wastewater, faecal matter or water contaminated with other substances. The pumped water should not
contain mechanical contaminants or other abrasive particles. Pumping contaminated water is acceptable solely when special
precautions have been taken and if the pumping process is being continuously controlled.
Attention! Any interruptions of the flow of water through the pump may lead to its irreversible damage!
The pump has been designed exclusively for household applications. It is prohibited to use the pump for professional and
commercial purposes. A correct, reliable and safe functioning of the appliance depends on its correct operation, so:
Before you proceed to work with the device, read thoroughly the operating manual and keep it for further reference.
The supplier will not be held responsible for any damage caused by failure to observe safety regulations and the recommendations
included in this manual.
EQUIPMENT
The original factory box contains a pump with a socket ferrule to connect a hose. The pump is not supplied with a pumping conduit
(hose).

TECHNICAL PARAMETERS

Parameter
Pump type
Power supply voltage
Power supply frequency
Nominal power
Insulation class
Protection grade (IP)
Maximum capacity
Water outlet diameter
Water outlet diameter
Maximum head
Maximum immerse depth
Maximum water temperature
Net weight
Cable length
Head high
[m]
0
12
24
36
48
60
Attention! In order to ensure the maximum efficiency of the appliance, connect to the pump a hose whose diameter corresponds to the maximum diameter of the water
connection.
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
O P E R A T I N G
GB
Measure unit
[V]
[Hz]
[W]
[dm 3 /h]
['']
[mm]
[m]
[m]
[ o C]
[kg]
[m]
Pump type
79942
Capacity [dm 3 /h]
1080
1000
900
800
600
300
I N S T R
Value
79942
~230
50
280
I
IPX8
1080
1/2
18
60
5
35
3,2
10
U C T I O N
7