Swann SwannBuddy Guia De Inicio Rapido página 5

MicroSD card
The SwannBuddy comes with a pre-installed 32GB microSD card. The microSD card is required for
the SwannBuddy to record events and perform firmware updates. You can easily replace the microSD
card with a new one (up to 128GB, minimum Class 10 recommended) if needed in the future. Simply lift
the rubber flap on the back of the SwannBuddy, eject the current microSD card (push in until it clicks)
from the microSD card slot and then replace with a compatible microSD card (ensure gold contacts
facing up). You should format any microSD card the first time you use it with the SwannBuddy. Go to
the device's advanced settings screen in the app and select Format.
Pairing the Chime with the SwannBuddy
You can pair the Chime with the SwannBuddy by following the steps below.
1 Press and hold the SET button on the Chime (about 3 seconds) until the LED indicator starts
blinking blue and you hear a voice prompt "Setup is in progress. Press the Doorbell to connect."
2
Press and hold the Doorbell button on the SwannBuddy for 3 seconds. The LED indicator on the
Chime immediately turns off, confirming successful pairing.
• Note: If you fail to complete pairing within 90 seconds, the LED indicator on the Chime will
automatically turn off. Repeat steps 1-2 to pair the Chime again.
3 To test the Chime, simply press the Doorbell button on the SwannBuddy. You will hear the "Ding
Dong" melody.
Changing the Chime melody
Once paired, you can change the Chime's default "Ding Dong" melody.
1 Press the SET button on the Chime once to select the next melody in the sequence.
2
Press the Doorbell button on the SwannBuddy to test the new melody.
3
Repeat steps 1-2 until you hear something you like. There are six melodies to choose from.
GETTING STARTED
EN
5