Quantum DLT-V4 Guia De Inicio Rapido página 2

DLT-V4 Tape Drive Quick Start Guide
Figure 1 Setting the SCSI ID
SCSI ID jumpers
6 Remove the cover from the server or workstation as
described in the server or workstation's documentation.
See figure 2.
7 SCSI Tape Drives Only — If necessary, install an LVD/SE
host bus adapter in the server or workstation.
8 SCSI Tape Drives Only — Connect an active LVD/SE
terminator onto one end of the SCSI cable, if the tape
drive is the last or only device on the SCSI bus (see
figure 2). If the SCSI cable that came with the SCSI host
bus adapter already has a terminator built into it, do
not use an additional terminator.
N : If the tape drive is not the last or only device
OTE
on the SCSI bus, make sure the last device on
the SCSI bus is properly terminated and is
powered on whenever you use the tape drive.
Figure 2 Removing the Cover,
Installing, and Terminating
9 SCSI Tape Drives Only —Connect the SCSI cable to the
tape drive and to the SCSI host bus adapter. Connect
the power cable to the tape drive (see
figure 3).
Figure 3 Connecting the SCSI
Cables to Rear of Tape Drive
SCSI cable (with terminator)
10 SATA Tape Drives Only — Connect one end of the
SATA data cable to the tape drive and the other end of
the SATA data cable to the SATA host bus adapter (see
figure 4).
11 SATA and USB Tape Drives Only — Connect either the
SATA power cable or drive power cable to the tape
drive (see figure 4).
C :
AUTION Connect only one power cable to the
drive. Connecting both the SATA power cable
and drive power cable to the tape drive may
damage the drive.
Figure 4 Connecting the SATA
Cables to Rear of Tape Drive
SATA
power
cable
Install EITHER
(not both)
12 Secure the tape drive in the selected server or
workstation with the appropriate M3 mounting screws
(see figure 5). Contact the computer manufacturer if
the server or workstation uses mounting rails for
internal tape drives.
Drive power cable
SATA
Drive
data
power
cable
cable
2