Use And Maintenance - Saivod CES619W Instalación

Drill 2 holes on the wall, which correspond to the position (B) of the drawing fig-1.
Hang the hood on the 2 holes by using the screws and doweis with expanding plug, which
are appropriate for that kind of wall (ex.: concrete, plaster- board, etc.). Fix definitely the
hood through the 2 security holes (Z).
CHANGING FROM EXHAUSTING HOOD TO THE FILTERING ONE
In order to make this change (possible also after the use of the exhausting system), demand
a set of carbon filters to your dealers. Active carbon filters are necessary to depurate the
air, that will be released in the room. Filters are not washable: they cannot be regenerated
and have to be replaced at most every 4 months. The saturation of the activated charcoal
depends on the more or less prolonged use of the hood, on the type of cooking and on the
regularity of cleaning the grease filter. The filter (C) has to be applied to the aspirating group,
which is inside the hood fit in the centre of the group with it and turning it of 90 degrees
until the stop click is heard to lock it. Remove the grill (G) to carry out this operation. Close
with the appropriate covers the upper and back air outlets; turn the small lever (L) from the
position (A) to the position (F). In this way the hood is ready for the filtering function.

USE AND MAINTENANCE

It is advisable to let the appliance work for 15 minutes after the cooking of the food in order
to remove completely the fumes. In the frontal part of the appliance there are an on/off
switch for the light, and a switch to change the working speeds. The effective functioning of
the hood depends on the regularity with which the maintenance operations are carried out.
in particular those of the anti-grease filter.
The anti-grease filter, which rests on the grill, has the function of catching the particles sus-
pended on the air, so it is subject to get clogged at various intervals, according to the use
of the appliance. In any case at most after two months, it is necessary to clean the filter by
doing the following operations:
• Remove the filter from the grill and wash it with a solution of water and neutral liquid de-
tergent, allowing the dirt to soften:
• rinse thoroughly with lukewarm water, allow to dry without twisting and apply it to the grill.
If the appliance is provided with a metal filter, it can be washed also in the dishwasher, dried
andreapplied to the grill.
GB
In case the washing instructions of the filter should not be followed, it could burst into flames.
Clean frequently all the deposits on the fan and on all the other surfaces. using a cloth moist-
ened by methylated spirits or neutral and not abrasive fluid detersive.
WARNING!!
UNDER CERTAIN CIRCUMSTANCES DOMESTIC APPLIANCES MAY BE DAN- GEROUS.
• Do not touch filters with hood working.
• Do not touch the lamps after a prolonged use of the appliance.
• No food must be cooked flambé underneath the hood.
• The use of an unprotected flame is dangerous for the filters and could cause fires.
• Watch constantly the fried food in order to avoid that the cooking oil flares up.
• Before performing any maintenance operation, disconnect the hood from the mains.
The Manufacturers refuse to accept any responsibility for eventual damages. because of
25