Publicidad
Idiomas disponibles
Idiomas disponibles
20. Outlet elbow
21. Suction cups
22. Spray bar
23. End cap
24. Inlet hose
25. Outlet hose
3. Spray bar:
Refer to the drawing to assemble spray bar. Clip on the suction cups. Then connect it with the outlet hose. Put this
aside and go to the next step.
4. Clean the filter media:
Release the lock of the motor head (top cover) by turning upward the knob (Fig 1). lift the motor head up to open the
cover (Fig 2). Rif off the bags of the active carbon and the ceramic rings. Wash with fresh water. Put the filter media
into the canister after the wash. The filter should be placed in the chamber next to the filter sponge.
fill the canister with clean water (IMPORTANT). If you prefer filling the canister later, do it after locking back the motor
head and refer to Fig 4 to remove the infill cover and fill water through the infill hole.
Lock the motor head to the canister by turning it downward (Fig 3). Make sure the O ring is firmly secured to avoid any
leakage.
5. Final assembly:
Connect the inlet hose of the inlet assembly of the filter, tighten it with the inlet nut. Connect the outlet hose of the
spray bar assembly with the outlet of the filter, tighten it with the outlet nut.
6. Install to the aquarium tank:
7
Publicidad
