Recalling And Editing The Ats Program; Clearing The Ats Program; Cd Display Messages; Using The Cassette Deck - RCA RP-9328 Guía De Usuario

Using the system

Recalling and Editing the ATS Program

Editing the ATS program is a lot like editing a
regular program.
1. Press the ATS button to go to AUTO TRACK SKIP
mode.
2. Press SET to move to the next program number
until you get to the programmed track you want
to change.
3. Press DISC CHANGE to choose the disc, and then
press or
4. Press the SET button to change the current skipped
track to the one you just selected.

Clearing the ATS Program

Clearing the ATS program is also a lot like clearing a
regular program.
1. Press the ATS button.
2. Press and hold the STOP button until CLEAR shows
in the display.

CD DISPLAY MESSAGES

When using the CD function, you may encounter the
following messages:
Message
CD
CLOSE
OPEN
NO DSC
EMPTY
NOTRK
FULL
14
to choose a replacement track.
Meaning
CD function is active. (In CD
mode, the disc carousel is
displayed with TOC or READ.)
CD drawer is in.
CD drawer is out.
There are no discs in the CD
drawer.
No tracks are programmed
(applies to both program and
ATS mode).
No tracks are available in
program play mode or ATS
mode.
Program is full (applies to both
Program and ATS mode).
READ Reading disc's table of contents
(how many tracks it has and the
total time for the disc). This
information is displayed in Stop
mode.

Using the cassette deck

RECORD / PLAYBACK • AUTO STOP
DECK
1

Playing Cassette Tapes

You can play cassettes from either of the two tape
decks.
1. Press the TAPE button.
2. Press STOP/EJECT( ) to open the cassette
compartment door.
3. Insert a cassette by gently sliding it into the cassette
carry compartment in the door with the exposed
tape downward.
NOTE: An internal interlock prevents the cassette
door from opening unless all controls are in the off/
up position.
4. Close the door securely.
5. Press REW ( ) or F.FWD (
desired starting point.
6. Press PLAY ( ) to begin playing the tape.

Continuous Tape play

You can play two cassette tapes in sequence.
1. Insert prerecorded cassette tapes into tape deck 1
and 2. Close both tape deck doors.
2. Press PLAY ( ) on tape deck 2.
3. Press PLAY ( ) and then PAUSE ( ) on tape deck 1.
4. When the tape in deck 2 finishes playing, the
pause on tape deck 1 will automatically release
and begin playing the second tape.
PLAYBACK • CONTINUOUS PLAY 2•1
DECK
2
) to move tape to the