Whirlpool 8535840 Instrucciones De Instalación página 12

Dura Safe
SURE CONNECT
Kits Make Installation Easy
Part #4396028
Kit Contains:
2 - 4' vent sections with attached close elbows
1 - Wall plate for close clearance installations
2 - 4" clamps
.
Dura Safe and Sure Connect are Trademarks of Whirlpool, U.S.A.
Moving dryer to a new
location?
Check with a licensed electrician to
confirm that supply voltage at new
home matches voltage specified on
the model/serial rating plate.
Part No. 8535840
© 2002 Whirlpool Corporation
TM
TM Vent Kit
Provides 4 1/2"
clearance between
dryer and wall
periscopes include one male
Snap-Lock fittings
snap-lock fitting, one extra
Total kit length 8 feet
Additional vent can
be snapped between
sections for
longer runs
Shut off electrical supply
to dryer. Unplug power
supply cord and tape it
securely to dryer. (Or
disconnect power supply
cable from dryer.)
Slide dryer onto cardboard or
hardboard before moving it across
the floor to prevent damaging floor
covering.
Benton Harbor, Michigan 49022, U.S.A.
Periscopes For Offset
Outlets, Tight Installations
Provides 2 1/2" clearance
between dryer and wall
Great for closet installations
0"-18", 18"-29" or 29"-50"
long draw-band collar and
one clamp
0"-18" Periscope
Use when vent outlets
overlap or are offset
Excess length can
be trimmed to fit
18"-29" and 29"-50" Periscope
Swivel collar
wall connection
Telescoping
sections
Beveled edges
allow corner
installations
18"-29" : Part #4396011 29"-50" : Part #4396014
For more information, or to
have your venting
professionally installed, call
the Consumer Assistance
Center. Check your Use and
Care Guide for a toll-free
number to call or call the
2 1 / "
2
dealer from whom you
purchased this appliance. The
dealer is listed in the Yellow
Pages of your phone
directory under "Appliances
— Household — Major —
0"-18" : Part #4396037
18"-29" : Part #4396011
Service and Repair."
29"-50" : Part #4396014
Part #4396037
Sections separate,
fittings can face
same or opposite
Swivel collar
Extra long
band-clamp
for dryer
connection
Tape lint collector lid to
cabinet.
Tape top to cabinet.
Tape door to
front panel.
Turn leveling legs
all the way in.
Printed in U.S.A.