Maxon 296805-01-200 Manual De Instrucciones página 3

LIFT CORPORATION Sht. 3 of 16 DSG#
NOTE: Connect the foot guard switch
tee, control switch cable and
wiring harness extension cable
before installing all operating
control switches.
3. Drill hole in vehicle rear sill under exten-
sion plate and away from moving parts
as shown in FIG. 3-1. Then, route foot
guard switch cable through hole (FIG.
3-1).
4. Disconnect wiring harness extension
cable from control switch cable on the
RH column (FIG. 3-2).
© MAXON Lift Corp. 2018
WIRING HARNESS
EXTENSION CABLE
M-16-01
1" DIA.
HOLE
DISCONNECTING WIRING HARNESS
FIG. 3-2
Rev. A Date: 08/23/18
EXTENSION
PLATE
SWITCH
CABLE
REAR
SILL
FRONT VIEW
FIG. 3-1