Cleaning And Maintenance - veito BLADE Manual De Instrucciones

veito
OPERATION
• Press the power button to turn the heater on.
• Press the level button then change the power setting by pressing the arrow buttons.
• Press the auto button then set the desired temperature by pressing the arrow buttons.
• Press the power button to turn the heater off.
• You can also use the button on the unit to operate the heater.
Note: lf the heater falls over, it will automatically switch off.
Replacing the battery
• Press the battery compartment release button and then slide out the battery tray.
• Remove the old battery and put the new battery in, making sure that the battery's
positive side is facing up. Use only a CR2025 battery in this remate control.
• Slide the battery tray back into the remate control until it clicks.
Note: Do not allow water or liquid to get into the remote control.

CLEANING AND MAINTENANCE

• Always disconnect the heater from the electricity supply and allow it to cool befare
attempting to work on it.
• lf the heater has collected dust or dirt inside the unit or around the heating element,
have the unit cleaned by a qualified service agent. Do not operate the heater in this
condition.
• The only maintenance required is cleaning of the externa! surfaces of the heater.
• Do not use powerful abrasive or solvent cleaning fluids when cleaning the heater as
they may damage the plastic parts. Use a damp cloth to wipe the outside of the heater.
• lf removed from its mounting position when not in use, store the heater carefully in a
safe, dry, childproof location.
• Do not touch the heating element with bare fingers, as residue from your hand could
affect the life of the lamp. lf it is accidentally touched, remove the finger marks with a
soft cloth moistened with methylated spirit or alcohol.
• Do not attempt to repair or adjust any electrical or mechanical functions on this heater.
• The heater contains no user serviceable parts. Should the product suffer damage or
breakdown, it must be returned to the manufacturer or its service agent.
• Damaged supply cords to be replaced by the manufacturer, service agent or similarly
qualified person in arder to avoid hazard.
• After sales service
• Your product is guaranteed far two years from the date of purchase.
• Within this period, we undertake to repair this product free of charge provided it has
been installed and operated in accordance with these instructions. Your rights under
this guarantee are additional to your statutory rights, which in turn are not affected by
this guarantee.
RECYCLING
Far electrical products sold within the European Community.
At the end of the electrical products useful life it should not be disposed of with
household waste. Please recycle where facilities exist. Check with your Local Authority
or retailer far recycling advice in your country.
-------------------11------------------