ENGLISH
Description and use
The product you have purchased is an axial centrifugal
aspirator used to ventilate rooms with single channel
exhaust. The product avoids traditional installations
inside rooms, avoids air return when the unit is off, and
softens room noise as it is installed outside the wall.
IMPORTANT: The unit is able to develop 3 ventilation
speeds, as it is already equipped with suitable
condensers. Operating speed control is designated to
pairing with an appropriate 3-speed selector. For
further information regarding the control device, see
the "Wiring diagrams" paragraph.
These appliances are designed
•
for
use
in
commercial properties.
Fans have been designed to be
•
mounted on external walls.
Safety
Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• Do not use this appliance for functions other than
those described in this booklet
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician or
Vortice
• Do not leave packaging within the reach of children
or differently able persons
• Certain fundamental rules must be observed when
using any electrical appliance, including:
- never touch appliances with wet or damp hands
- never touch appliances while barefoot.
• If you decide to stop using the appliance, switch it off
and disconnect it from the power supply, storing it
out of reach of children and infirm persons
• Do not use the appliance where flammable vapours
are present (spirit, insecticides, petrol, explosives,
etc.
This appliance can be used by
•
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
Children shall not play with the
•
appliance.
Cleaning and user maintenance
•
residential
and
shall not be made by children
without supervision.
Precautions must be taken to
•
prevent gas coming from the gas
flue pipe or from other fuel
combustion units from entering
into the room.
Products installed without a
•
protective device for moving
parts must be installed at a
height greater than 2.3 m above
the floor level.
Units equipped with manual
•
reset thermal breaker device
In order to avoid any danger of
accidental reset of the thermal
breaker device, units must not be
powered by an external switch
device such as a timer, or must
not be connected to a circuit that
is
regularly
disconnected from power utilities
powered
or
9