Freehand Routing; Protecting The Environment - DeWalt DW624 Traducido De Las Instrucciones Originales

EngLIsh
Switching On and Off (Fig. A, B, E)
1. On: pull the switch up.
1
2. Off: press the switch 1 down.

WARNING: Loosen the plunge limiter and allow the router
carriage to regain its rest position before switching off.
Using the Guide Bushes (Fig. I)
1. Secure the template to the workpiece using end clamps.
2. Select and install an appropriate guide bush
3. Subtract the diameter of the cutter from the outside
diameter of the guide bush and divide by 2. This is the
difference between template and workpiece.

WARNING: If the work piece is not thick enough, place it
on a piece of waste wood.
Guiding Off a Batten
Where an edge guide cannot be used, it is also possible to guide
the router along a batten clamped across the workpiece (with
an overhang at both ends.)

Freehand Routing

Your router can also be used without any sort of guide, e.g. for
signwriting or creative work.

WARNING: Make shallow cuts only!
Use cutters with a max. diameter of 6 mm.
Routing with Pilot Cutters (Fig. C)
Where a parallel guide or guide bush are inappropriate, it is
possible to use pilot cutters 24
These include collets (6 – 12.7 mm), a height adjusting tool and
router table for use in inverted position, finger jointing tools
for dovetail and finger jointing jigs, dovetail jointing templates,
adjustable guide bush holder and guide bushes and guide rails
in various lengths.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Lubrication
Your power tool requires no additional lubrication.
24
31 .
for cutting shaped edges.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
WALT recommended
e