ARIETE DigiMix professional 1566/1 Manual De Instrucciones página 8

E N
DESCRIPTION OF THE APPLIANCE (Fig. 1)
A Rotating bowl
B Arm tilt button
C Support
D Tool release button
E On/Off button
F Handgrip
G Speed buttons
H Display
I Power body release button
L Kneaders
M Traditional whisks
FITTING AND REMOVING TOOLS
CAUTION: ALWAYS UNPLUG THE POWER CORD FROM THE ELECTRICITY MAINS BEFORE
FITTING OR REMOVING SINGLE ATTACHMENTS OR BEFORE CLEANING THE APPLIANCE.
NOTE: The whisk attachments need to be fitted to the power body before the body can be fitted onto
the support (C).
- The appliance has two types of whisk attachment for use as required by the type of mix:
- pair of traditional metal whisks (M) for whisking mayonnaise, sauces, cream and egg whites;
- pair of kneaders (L) for mixing doughs.
- To fit the whisks, take the appliance by the handgrip (F) and insert the shaft of each whisk into the
relevant hole, until it clicks into place.
The whisks in the pair are not identical and therefore, the one with the plastic gear mechanism
needs to be fitted into the hole on the left (Fig. 2).
- To remove the whisk attachments, first remove the power body from the support (C) and then
press the relevant eject button (D) and pull out the whisks (Fig. 3).
IMPORTANT: Never press the release button (D) while the appliance is operating.
INSTRUCTIONS FOR USE
IMPORTANT: MAKE SURE THAT THE WHISK ATTACHMENTS ARE FITTED CORRECTLY
BEFORE USING THE APPLIANCE.
- Place the support (C) on a flat, steady surface.
- Press the arm tilt button (B) and at the same time, lift the arm on the support (C) upwards (Fig. 4).
- Place the bowl (A) in the special space, inserting it perfectly over the pin in the base (C) of the
support (Fig. 5).
- Fit the motor body complete with whisk attachments onto the arm, inserting it from the front of the
support (C) and so that the whisks fit into the two slots. Slide it downwards, pressing gently until
the plastic gear mechanism on the left whisk attachment clicks into place inside the slot on the arm
(Fig. 6).
- Pour the ingredients into the bowl (A) and pressing the arm tilt button (B) lower the arm of the
support (C) using the handgrip (F) on the power body (Fig. 7).
- Plug the power cord into a mains power source.
- 6 -