Using The Remote Control Unit - Astone i-NAP Manual Del Usuario

Using the Line-in Cord
a) An audio line-in cord comes with the unit. Use it to play other audio devices through the
unit. Press the Mode Button until AUX appears on the display. Store the audio line-in cord
properly in provided plug holder when not in use to avoid static charge which can interfere
with proper operation.
Replacing Backup Batteries
Install / Replace Backup Battery
The unit uses a backup battery system to memory all
setting in the event of a power failure. If the Battery
low there is no appears on the display, it is time to
replace the backup batteries.
Open the battery compartment cover located on the
bottom of the unit. Insert 3 'AA' batteries as indicated.
We recommend the use of alkaline batteries for
longer life.
Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
recharge able (nickel-cadmium) batteries.
7

Using The Remote Control Unit

Power On / Off (Same as 6 )
Skip + / - (Same as 2 )
iPod Play / Pause
(Same as )
3
Install / Replace the Remote Control Battery
The remote control battery is already installed with pull tab,
at the factory. Remove pull tab before use. When the
remote control stop operating or its range seems reduced,
replace the battery with a new one.
1) The battery door is located on the back end of the unit.
2) Squeeze notched tab A while pulling battery door latch
B to release the battery doo latch and take out the
battery holder.
AM / FM Select Button 9
Mode (Same as 7 )
Skip / Button 12
Snooze / Dimmer Button 1
A
8