Connecting Your Monitor To Your Computer - IBM P275 Guía De Instalación Rápida

Connecting your monitor to your computer

Step 1. Ensure the monitor and computer are
turned off.
Step 2. Connect the appropriate end of the video
signal cable to the video output of your computer.
Note: Do not force the connector in the wrong way. If the
connectors do not fit, check the alignment of the connector,
or try the other end of the video signal cable.
Step 3. Connect the other end of the video signal
cable to the appropriate input of the monitor.
Note: If you attached the video signal cable to connector 1
on the back of the monitor, set the input switch on the front
of the monitor to 1.
AC IN
Step 4. Connect the power cord to the monitor and
then connect the other end to a properly grounded
power outlet.
Step 5. First turn on the monitor then turn on the
computer.
The installation of your monitor is complete. If necessary,
use the monitor controls to adjust the picture. If no picture
appears on your screen, refer to the table on the following
page. The User's Guide and monitor installation files are on
the IBM Monitor CD.
English
English