General Instructions; Support Installation - Toparc RC-HA2 Manual De Instrucciones

WARNING - SAFETY RULES

GENERAL INSTRUCTIONS

Read and understand the following safety recommendations before using or servicing the unit.
Any modification or servicing that is not specified in the instruction manual must not be undertaken.
The manufacturer is not liable for any injury or damage due to a non-compliance with the instructions featured this manual.
In the event of problems or doubts, please consult a qualified person to handle the installation properly.
OPERATION
This remote control is designed to work with MIG / MAG welding processes. It can remotely set the wire speed (button n°1, fig 1) and the welding
voltage about the station (button n°2, fig 1). For further details, check the wire feeder's manual.
Compatible machines : NEOFEED/PULSFEED, EXAFEED/GENFEED.

SUPPORT INSTALLATION

The analogue remote control support can be fitted on the trolley (option, ref. 032736).
4
PROFIL
M6x10
(x2)
M6
(x2)
RC-HA2
Unscrew the 2 screws (M6X40) on the trolley. Do not throw away.
M6x40
(x2)
M6
(x2)
Fit the 2 screws (M6X40) previously remove.
EN
FRONT