Gammapiu 025 Manual Del Usuario página 14

• Start at the highest setting of the supplied guide comb (12 mm) and gradually
reduce the setting of the hair length using the other guide combs supplied (9-
6-3 mm).
• For best results, use the appliance against the direction of hair growth.
• If hair starts to clog the guide comb, remove the guide comb from the appliance (see
par. "Removing the guide comb") and clean away the hair (blow and/or brush out).
USING THE APPLIANCE
Use of the cutting guide comb
To insert the guide comb (fig. A1), follow the instructions below:
• Check that the appliance is off.
• Slide the guide comb onto the head until you hear it click into place (Fig. C).
• Ensure that the guide comb is correctly inserted in the slots on either side.
• Turn on the appliance as indicated in par. "TURNING THE APPLIANCE ON AND OFF. "
• Cut the hair; for tips see par. "USEFUL TIPS FOR CUTTING".
Turn off the appliance before changing or inserting any accessories.
Removing the guide comb
• Turn off the appliance.
• Push the guide comb so that it slides off the appliance (Fig. C1).
Using without the guide comb
When using the appliance without the guide comb, the blade of the
head (2) will cut the hair very close to the skin.
The appliance can be used without the guide comb to cut hair very close to the skin
(1.0 mm) or to redefine the hairline of the neck and around the ears.
If the appliance has been used with the guide comb and is then to be used without it,
remove the comb as described in par. "Removing the guide comb".
Instructions to adjust the cut
The clipper has four adjustable lengths: 1.0 /1.3/1.6/1.9 mm.
Rotate the ring 14 (fig. A) clockwise or anticlockwise (fig. D) until the indicator
reaches the desired height 15 (fig. A). The height can be adjusted from 1.0 mm to 1.9
mm in 0.3 mm steps without using the guide combs.
MAINTENANCE
In case of malfunction or damage to the appliance or a part of it, the
appliance must be analysed by the manufacturer or the relevant technical
assistance or in any case by a person with similar skills in order to prevent any
risk. The user must not disassemble the device him/herself.
GENERAL CLEANING
Always disconnect the power cord from the mains socket before
cleaning.
• Avoid all risk of electric shock by not cleaning the appliance with water and do
not immerse it in water.
• Do not use abrasive solutions or concentrated detergents.
• Clean the exterior with a soft cloth or slightly damp cloth.
• After use, make sure that all parts are completely dry.
Removing the cutting head
• Turn off the appliance and remove the power adaptor from the mains socket 9
(fig. A).
• Remove the guide comb in compliance with the instructions reported in "Using
without the guide comb. "
• Keep the appliance with the switch facing upwards.
• Press the centre part of the head 2 (fig. A) downwards using your thumb until it
opens (fig. E); then extract it from the appliance.
• Take care not to drop the head.
Blade block cleaning
• Remove the head 2 (fig. A), as indicated in the paragraph "Removing the cutting head. "
14
When cutting close to the ears, you are advised to use
your hand to protect your ear against injury.