Troubleshooting - Waldbeck Huygens 10032850 Manual Del Usuario

Station météo professionnelle
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

EN
142

TROUBLESHOOTING

Problem
Outdoor sensor
array does not
communicate to the
display console.
Temperature sensor
reads too high in the
day time.
Solution
The sensor array may have initiated properly and
the data is registered by the console as invalid,
and the console must be reset. Press the reset
button as described in section "Reset Button and
Transmitter LED". With an open ended paperclip,
press the reset button for 3 seconds to completely
discharge the voltage. Take out the batteries and
wait one minute, while covering the solar panel to
drain the voltage. Put batteries back in and resync
the console with the sensor array about 3 metres
feet away.
The LED next to the battery compartment will
flash every 16 seconds. If the LED is not flashing
every 16 seconds, you should replace the batteries
in the outside sensor array. If the batteries were
recently replaced, check the polarity. If the sensor
is flashing every 16 seconds, proceed to the next
step.
There may be a temporary loss of communication
due to reception loss related to interference or
other location factors, or the batteries may have
been changed in the sensor array and the console
has not been reset. The solution may be as simple
as powering down and up the console (remove AC
power and batteries, wait 10  seconds, and reinsert
AC power and batteries).
Make certain that the sensor array is not too close
to heat generating sources or strictures, such as
buildings, pavement, walls or air conditioning units.
Use the calibration feature to offset installation
issues related to radiant heat sources.

Hide quick links:

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido