Replacing Batteries; Technical Specifications - Vetus WRC Manual De Manejo Y Instrucciones De Instalación

4 Replacing batteries

From the backside remove both stainless
steel clamps and remove the rear part of the
housing. Remove the electronic circuit from
the housing and replace the battery.
Battery type CR2032.
Reassemble it in reverse order.
5 How to add and program
additional transmitters
Each new transmitter must be added. A maxi-
mum of 5 transmitters can be coupled to one
receiver. If a 6 th transmitter is added the 1
transmitter will be deleted from the memory of
the receiver.
2 sec.
1

6 Technical specifications

Remote control
Power supply
Protection class
Frequency
Temperature range
Weight
vetus® Radio Remote Control
2
: 3 V CR2032 (1x)
: IP66
: 433.92 Hz
: 0 - +70°C
(+32 - +158°F)
: 50 g (2 oz)
Procedure to add a new transmitter to the re-
ceiver:
1. Make sure that the wiring of the receiver
is connected and the power supply swit-
ched on.
2. Press and hold the 'ON' key for about 2 se-
conds to switch on the new station.
3. Press and hold the 'PROG. ' key until the red
LED is on (approx. 4 sec.).
4. On the new transmitter, press one of the
keys and keep it pressed until the bow
thruster is switched on.
5. The transmitter is now logged on.
st
PROG.
4 sec.
Receiver
Power supply
Protection class
Frequency
Temperature range : 0 - +70°C (+32 - +158°F)
Weight
Maximum current
(per output)
ENGLISH
15 sec.
3
: 8 to 30V DC
: IP40
: 433.92 Hz
: 800 g (28 oz)
: 8 A (at max. 30 Volts DC)
060217.01
5