Dmx Connection; Dmx512 Connection; Cleaning And Maintenance; Technical Specifications - Velleman HQ POWER VDP900HZ Manual Del Usuario

7. DMX Connection

a. DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDP900HZ. Multiple VDP900HZs can be linked through serial linking. The linking cable should
be a two-core screened cable with XLR input and output connectors.
b. DMX-512 Chain with Termination
c. DMX Start Address
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDP900HZ.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDP900HZs will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will
only affect the device in question.
In the case of the 1-channel VDP900HZ, you will have to set the start address of the first VDP900HZ to 1, the second
VDP900HZ to 2 (1 + 1), the third to 3 (2 + 1) and so on.

8. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections.
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Clean the machine every 40 hours of operation. Use 80% water mixed with 20% vinegar.
a) Dismount and clean the nozzle with vinegar and make sure there are no particles left.
b) Empty the tank and fill with the cleaning mixture of water and vinegar. Spray the mixture until the tank is
empty.
c) Reassemble the nozzle and pour the smoke liquid for the next operation.
6. There are no user-serviceable parts.
7. Contact your dealer for spare parts if necessary.

9. Technical Specifications

Power Supply
Power Consumption
Tank Capacity
Haze Output
Dimensions
Total Weight
For more info concerning this product, please visit our website www.hqpower.com.
The information in this manual is subject to change without prior notice.
VDP900HZ_v2
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120Ω resistor between pins 2 and 3, which is then plugged into
the XLR output socket of the last device in the chain.
Please see illustrations.
max. 230VAC / 50Hz
max. 900W
1.3 litres
285m³/minute
490 x 200 x 185mm
7.5kg
4 VELLEMAN