TRCV4 – RADIO-CONTROLLED MOTORCYCLE
1. Introduction & Features
Thank you for buying the TRCV4! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Keep the device away from children under three years of age.
• Do not use the TRCV4 on the road, in crowded places or in water / humid environments.
• Do not put the TRCV4 near heating devices.
• Remove the batteries from the motorcycle and the remote control after use.
3. Remote Control
Fig.1
1. Forward (accelerator handle)
2. Stop
3. Left turn (steering handle)
4. Right Turn
5. On/off switch
6. (at the rear:) battery compartment.
4. Preparations
1. Charge the 7.2V battery pack beforehand.
2. Install the battery pack into the motorcycle (bottom side). Turn the locking pads to fix/release the battery pack.
3. Install the battery into the remote control (fig.1 #6).
4. Switch the remote control on (fig.1 #5).
Fig.2
5. Switch the motorcycle on (fig. 2).
5. Use
• Make sure the surface on which you are going to ride is fairly smooth.
• Hold the motorcycle upright, press the accelerator forward and release the motorcycle after a few seconds.
• Alternately, put the motorcycle on the ground and press forward until it starts moving and stands up of its own.
• To stop the motorcycle, simply release the accelerator handle or pull it back to brake.
• Set the power switches of both the motorcycle and the remote control to "OFF" to stop using the device.
• Remove the batteries from the motorcycle and the remote control after use.
6. Troubleshooting
If the device is not operating properly:
• Are the batteries OK/charged?
• Are both the motorcycle and the remote control switched on?
• Is any nearby device operating on the same frequency (27MHz)?
• Are the wheels of the motorcycle not blocked?
TRCV4
1
VELLEMAN