Basic Troubleshooting; Resetting Factory Settings - Polk Signa S3 Guia De Inicio Rapido

CLEARING ALL LEARNED IR CODES
Press and hold the Source
about 10 seconds. When the all LEDs on the front of the
soundbar blink in purple five times, release the button.

BASIC TROUBLESHOOTING

The HDMI Control function does not work
・   Y ou cannot operate devices that are not compatible with
the HDMI Control function. In addition, depending on the
connected device or the settings, the HDMI Control function
may not work. In this case, operate the external device
directly.
・   C heck that the HDMI Control function setting is enabled on
all devices connected to this unit.
No sound is produced from subwoofer
 ・  T he Signa S3 sound bar and wireless subwoofer are preset
at the factory to work together. Should your wireless
subwoofer stop receiving an audio signal, follow these
instructions to re-establish the connection:
1. Turn on your sound bar.
2. Press and hold the CONNECT button on the back of the
subwoofer for 3 seconds.
3. Simultaneously press and hold Bluetooth
Up + buttons on the sound bar for 5 seconds.
The sound bar will search for a connection while the first and
second LEDs on the sound bar will flash intermittently. The
lights will stop flashing when the sound bar and subwoofer
connect. If the sound bar and subwoofer fail to connect, the
first and second LEDs will flash together 5 times. Repeat
steps above to establish a connection.
Cannot pair with a Bluetooth device
・   I t may be that Bluetooth is not enabled on the Bluetooth
device. See the Owner's Manual of the Bluetooth device to
enable the Bluetooth function.
・   T his device may be paired with another Bluetooth device.
Select this unit from the list of devices displayed on the
screen of the Bluetooth device.
・   B ring the Bluetooth device near to this unit.
・   T urn the power of the Bluetooth device off and on again,
and then try again.
・   O nly 1 Bluetooth device can be connected at a time.
Polk SignaS3_QSG_200302.indd Polk SignaS3_QSG_200302.indd 6 6
button on the sound bar for
and Volume
The sound from a Bluetooth device is cut off
・   B ring the Bluetooth device near to this unit.
・   R emove obstructions between the Bluetooth device and this
unit.
・   T o prevent electromagnetic interference, locate this unit
away from microwave ovens, wireless LAN devices and
other Bluetooth devices.
・   P air with the Bluetooth device again.

Resetting factory settings

Perform this procedure if the display is abnormal or if
operations cannot be performed. Various settings are reset to
the factory default values. Make settings again.
1. Press thePower On/Off button to turn on power to the
unit.
2. Press and hold the back panel's RESET button for at least 5
seconds.
・   A ll the Front LEDs blink simultaneously 3 times in red.
・   S igna S3 automatically restarts in a factory default values.
Specifications
Sound bar
Power supply: AC 100 - 240 V,
50/60 Hz
Operating temperature:
5 °C - 35 °C
Power consumption: 40 W
Power consumption in standby
mode:
1.80W
Power consumption in deep
standby mode: 0.35W
Subwoofer
AC 100 - 240 V,
50/60 Hz
5 °C - 35 °C
40 W
0.35W
0.35W
6
2020/03/03 2020/03/03 17:00:29 17:00:29