Kalorik USK KS 1 Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FIXING THE WALL-MOUNTING BRACKET (see
picture A)
Select a point in the vicinity of a wall socket,
indoors and not subject to damp.
Put the bracket against the wall considering
that the appliance should be placed with the
handle facing upwards.
Take a pencil and mark a dot in each hole
situated at the back of the bracket
Take the bracket off the wall and drill a hole on each dot you just
marked.
Put a plug in the holes and tighten the screws in the holes, letting
them more or less 4 millimeters out of the wall.
Fix the bracket by putting the screws into the widest part of the
holes situated at the back of the bracket and slide the bracket
downwards.
CHARGING THE VACUUM CLEANER
Before using your vacuum cleaner for the first time, charge the
battery during approximately 16 hours. A fully charged battery will
give approximately 10 to 12 minutes vacuum cleaning.
The charger should only be connected to a 120V, 60Hz power
supply.
Important: The charger and its cord cannot be repaired. Should they
be damaged, they must be thrown out. Contact the customer
service to replace them.
Put the "jack" plug of the charger in the opening foreseen
underneath the wall-mounting bracket and rotate it until it is firmly
attached to the bracket (see picture B).
B
5
A
USK KS 1 - 060104

Publicidad

Tabla de contenido
loading

Tabla de contenido