JetAir Lilly IX/A/90 Montaje Y Modo De Empleo página 22

Operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Model with 4 push-buttons control panel
a. ON/OFF light switch
b. Speed 1/OFF switch
c. 2-speed selection
d. 3-speed selection
Functioning - Model with display
F1 – ON/OFF Timer (Automatic Shut-off/Off)
The Timer function is activated with the engine running (at any
speed); after 5 minutes, the engine shuts down automatically.
During the timing phase, the display (D) shows the remaining
working time, in minutes (flashing).
To stop the timer function, before these 5 minutes, press
again the F1 key.
Note: By turning off the engine manually (via F3), the timer
function is deactivated.
F2 - ON / OFF Lights
Allows turning on and off lights.
F3 – Engine Speed Decrease / OFF
Decreases the speed of the engine, until it shuts off.
F4 - ON / Engine Speed Increase
Enables the startup of the engine and the speed increase,
from 1 ° to 3 °.
D - Display
Allows the viewing of:
- the motor speed status
- the remaining time to Automatic Shut-off, when the Timer
function is activated
Functioning - Model with display
T1. ON / OFF Timer (Automatic shut-off) - and – Clock
Setting
The timer function can be activated with the engine running (at
any speed); after 5 minutes, the engine shuts down
automatically.
During the timing phase, the display (D3) displays the
remaining working time (mm: ss).
To interrupt the timing function, before these 5 minutes, press
again the T1 button.
Note: By turning off the engine manually (via T3), the timer
function is deactivated.
Setting the clock
The clock setting is performed through keys T1, T3 and T4
(irrespective of lighting condition, engine or timing)
By holding the T1 button for 3 seconds, you can enter "Clock
Setting":
- The hour digits will be flashing
Press keys T3 (-) and T4 (+) to set the clock "setting NOW"
Press again (briefly) the T1 key:
- The minute digits will be flashing
Press keys T3 (-) and T4 (+) to set the clock "setting
MINUTES"
Note: the flashing phase has a duration of 3 seconds; if the
operator does not press any key within this time, the existing
setting is re-stored.
T2. ON / OFF Lights
Allows turning on and off lights.
Note: by turning on the lights, the display illuminates.
T3.Engine Speed Decrease / OFF
Decreases the speed of the engine, until it shuts off.
T4. ON / Engine Speed Increase
Enables the startup of the engine and the speed increase,
from 1 ° to 3 °.
D. display
The display backlight is activated by turning on lights and/or
motor.
Hood functions display:
D1 – function Timer ON
D2 - Lights ON
D3 - clock (hh: mm) / time remaining to Automatic Shut-off
(mm: ss)
D4 - motor on
D5 - hood in operation: lights/motor.
22