Safety Notes - marklin 60821 Manual De Instrucciones

Safety Notes

• The motor control is determined by the connections to
the m83 (60831).
• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• The voltage supply to the motor control is done exclusi-
vely by means of the m83.
• Connections to the m83 decoder should only be done
when all voltage is turned off.
• WARNING! Sharp edges and points required for operation.
• Motor control is designed only for use in dry areas indoo-
rs.
Connections for Motor Control and Required Settings
The motor control is connected to the terminal clips for turn-
outs on the m83 decoder. Maximum load for motor control is
500 milliamps.
The required CV settings for operation can only be adjusted
in the DCC mode. When doing this bear in mind the ope-
rating instructions for the m83 decoder (Pages 20-21). The
settings remain preserved and in effect in MM/fx.
4
CV-Settings:
Switching Function Turnout, red
Pulse Width (Regulating speed)
Period (Regulating time)
Switching Function Turnout, green
Pulse Width (Regulating speed)
Period (Regulating time)
The CVs arrange themselves according to the turnout con-
nections to which the motor control is connected.
The rotational direction of the motor can be adapted by
swapping the wires at the terminal clips for the motor
control..
Max. 500 mA
M
min - max
= Value 17
= Value 1 -255
= Value 50 - 200
= Value 17
= Value 1 -255
= Value 50 - 200