Connecting Signals; Controlling Signals - marklin 72760 Manual De Instrucciones

Connecting the Signal
2-conductor contacts on the back of the control box. All
eight connections are the same and are not assigned to any
particular button. The assignment between button and signal
results from the address of the signal.
Addresses
1 2

Controlling Signals

The signal is controlled by pressing on the button. If the
green LED is on at the button on the control box, the signal
will display "go".
10
3 4
Signal aspect
If the LED is off, the signal shows "Stop".
Other Possible Signal Aspects and Their Assignment.
Multi-aspect signals can be assigned to only one control box.
Two (2) buttons (addresses) are required. After setting the
basic address, the signal assigns on its own the sequential
address. The following button combinations (addresses) are
possible, 1 + 2, 2 + 3, or 3 + 4.
Signal aspect
Signal aspect
Signal aspect