Braun BLACK400 WiFi Solar Manual De Instrucciones página 26

turn off. At the same time the APP will exit the connection screen
synchronously.
26. After completing the use of APP, you can quit the APP, enter the phone
to turn off WIFI and Bluetooth, and the device will automatically enter
ON or SETUP mode.
27. When the camera turns ON WIFI or forgets to turn off WIFI after using,
the camera will also be disconnected from the mobile phone network, after
reaching the default time of "automatic WIFI off", the camera will
automatically quit WIFI and return to ON(monitoring) or SETUP mode.
Description of Operating mode
1. Calibrate the installation position of camera
In the test mode, the best shooting angle and range of the camera can be
calculated.
●When calibrating, you can check the LED indicator lights of the PIR
Sensors for help during calibration.
●The steps to calibrate the camera position are as follows:
1.1 Tie the camera to a tree or an object of 1-2m high, adjust the direction
of the camera's lens.
1.2 If the indicator light of the corresponding PIR sensor is on, it means
that the PIR sensor has detected a moving object. In this way, the best
position for installing the camera can be calculated.
1.3 The indicator light will be on only when the sensor detects moving
objects in the test mode, and the LED will be off in monitoring mode.
1.4 Ensure that the camera will not be interfered unnecessarily when it
is working, and avoid direct sunlight near the branches.
2. Normal operation mode
●In this mode, the camera is triggered by the sensor and enters the life