V-TAC VT-3042-3 Manual De Instrucciones página 6

ENGLISH
STEP 2. INSTALLATION OF THE HANGER SYSTEM
• Get off the pin from the downrod by removing the R clip, and get the lead wire through the
downrod, canopy and the connector, then seat the downrod into the fan body & rotate the
the downrod until the holes on the downrod will match with the holes on the fan body, final-
ly, you should get the pin through the holes and fix the pin by the R clip by another side
(Fig. 3).
• Place the downrod with hanger ball into the mounting bracket, rotate the motor assemble
until the Tab" on the mounting bracket has dropped into the "Registration Slot" on the hang-
ing ball and seat firmly (Fig. 4 & 5).
FIG 3 FIG 4
FIG 5
CONNECTOR
R CLIP
SET SCREW