General Information - Ebode RPT Guía Del Usario

Transceiver - Plug-In Transceiver Module
Installing the appliance module
NOTE: Make sure the appliance or light is powered on.
X10 address
The X10 address consists of a House Code and a Unit Code.
In order for this module to respond to a command sent via the
Power line, the module needs to be initialized.
It is possible to configure multiple addresses for this module.

General information

- The RPT transceiver module can be configured to respond to up to 32 X10
addresses and 16 Secure ebode addresses.
- The factory default the protocol is set to X10 mode.
- The LED will blink green when receiving radio signals.
- The LED will blink red when ON/OFF command for a configured address are
received.
Programming the RPT module
1. Use a small sharp object, e.g. a paper clip, to shortly press the
setup button. This button is situated in the small opening between
the two LEDs. When the button is pressed, the green led will blink
quickly, waiting for a command.
2. Send the 'power on' command for the desired address.
3. The led will stop blinking.
4. The appliance module address is now stored.
5. If you wish to configure additional addresses repeat this procedure
form from step 1.
July 2009
1. Plug the appliance
or lamp into the
module.
page 6
Ref : RPT
2. Plug the module
into a socket.
RPT