Sanus CAPT01 Instrucciones De Montaje página 3

IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE
Thank you for choosing a Sanus Rack Accessory. The CAPT01 SANUS EcoSystem™ Multi-volt Power Supply is designed to work
with any 19 in. (48.26 cm) rack.
CAUTION:
Avoid potential personal injuries and property damage!
 To Reduce the Risk of Electric Shock - Use Only in Dry Locations Indoors!
 The input plug of this power tap is intended to serve as the disconnect device, it shall be easily accessible and withdrawn.
 This power center does not contain internal circuit breaker protection. INSTALLER MUST ensure that the input of this
power center is connected individually to an electrical service panel that is protected with a UL Listed 20A (Maximum)
circuit breaker for overload protection of the power center.
 All doors and accessories must be grounded.
 Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature
of the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the
equipment in an environment compatible with the maximum ambient temperature (0-40°C/32-104°F) specifi ed by the
manufacturer.
 Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air fl ow required for safe
operation of the equipment is not compromised.
 Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved
due to uneven mechanical loading.
 Circuit Overloading - Consideration should be given to the connection of the equipment to the supply circuit and the
eff ect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration
of equipment nameplate ratings should be used when addressing this concern.
 Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given
to supply connections other than direct connections to the branch circuit (e.g. use of power strips).
 Do not use this product for any purpose not explicitly specifi ed by manufacturer.
 If you do not understand these instructions, or have doubts about the safety of the installation, assembly or use of this
product, contact Customer Service or call a qualifi ed contractor.
 Manufacturer is not responsible for damage or injury caused by incorrect assembly or use.
WARRANTY
The CAPT01 SANUS EcoSystem™ Multi-volt Power Supply is covered by a fi ve year product warranty against manufacturer's
defects. If you have any questions or experience any problems with your Sanus product, please contact Sanus Customer
Service.
Specifi cations
 Designed to work with any 19 in. (48.26) rack.
 Power Input Connection: IEC 320 C14
 Thermostat cycles on at 85° ⁄ off at 70°± 6°
 Input: 100 to 240V AC 50/60 Hz 3 A Max
 Outputs:
USB Charging
USB Charging - 5V
(per jack and total)
6901-002137 <01>
English
Lights
2.1 A Max
12V 1.2 A Max
(per jack)
12V DC 10 Amps Max
Always on
12V 2.5 A Max 12V
(per jack)
Thermostat
Controlled
2.5 A Max
(per jack)
3