Technical Specifications - Flex ALC 2/1–Basic Instrucciones De Funcionamiento Originales

ALC2-1.book Seite 15 Donnerstag, 25. Juni 2015 10:28 10

Technical specifications

Cross-line laser ALC 2/1
Visible laser diode
Laser class
Work area
– Horizontal/vertical beam
Precision ...
– Horizontal/vertical beam
Self-levelling range
Power supply
2)
Operating duration
Temperature range
– for operation
– for storage
Weight (with batteries)
1) The measurement range may be less under
unfavourable conditions (bright sunlight,
reflective surfaces).
2) The operating duration was determined with all
635 nm
Instructions for use
2
1)
20 m
– Do not point the laser beam at people or
– Do not look into the laser beam.
± 0.3 mm/m
– Do not put any optical instruments in the path
± 4°
This measuring instrument generates laser
3 x LR6/AA
radiation which may cause blindness.
12 h
– Do not use the measuring instrument in
–5 °C ... 50 °C
–20 °C ... 70 °C
– After using the device, immediately switch it
421 g
– If the device is brought from a very cold to
activated laser beams. The operating duration can
be extended if beams which are not required are
switched off by selecting a different operating
mode.
WARNING!
animals.
of the beam.
CAUTION!
a damp, dusty or sandy environment.
Device components may be damaged.
off with the On/Off switch in order to block self-
levelling.
a warmer environment or vice versa, you
should allow the device to acclimatise before
using it.
FLEX ALC 2/1–Basic
15