Connection/Installation; Rm-P2580 System; System With Up To 8 Cameras - JVC TK-C1460 Instrucciones

CONNECTION/INSTALLATION

RM-P2580 System

System with up to 8 cameras

Camera
TK-C1460
Camera 1
MACHINE ID:1
(Menu screen)
RX TERM: OFF
Camera
(switch)
TK-C1460
Camera 2
MACHINE ID:2
(Menu screen)
RX TERM: OFF
(switch)
Camera
TK-C1460
Camera 8
MACHINE ID:8
(Menu screen)
RX TERM: ON
(switch)
Remote Control Unit
When controlling with any system except the RM-P2580, execute proper settings using
switches and menu screens according to the systems used. (
MEMO
• When operating a system using the RM-P2580, several cameras (up to 16) can be
connected and used on one control signal cable. Consequently, an incorrect switch setting
on just a single camera will cause the entire system to work incorrectly.
• Confirm switch settings on the screen as follows.
q Confirm that the image from the camera to be checked
is displayed on the monitor.
w Turn OFF and then ON the AC 24 V power to the
camera to be checked.
e The camera begins the initial operation and charac-
ters similar to those shown in the illustration on the
right appear on the monitor screen.
r Confirm that "DUPLEX" and "ID-□□" are displayed
and that the ID number is the correct number (the
number should be the same as the number of the
VIDEO INPUT terminal to which the camera is con-
nected on the rear panel of the RM-P2580).
t If wrong, set the camera ID again.
E-12
Control signal cable
Video signal cable
AC24V
Power
or
cable
DC12V
AC24V
or
DC12V
AC24V
or
DC12V
TO
CAMERA
TO CAMERA
RX RX TX TX
POWER
RM-P2580 ON OFF
TO CAMERA
RX
AC INPUT
ON
CAM SW
• • • • •
OUT
CAMERA
SW COM
DATA I / O
UNIT CAMERA
COM COM 9/1 10/2 11/3 12/4 13/5 14/6 15/7 16/8 COM AUTO ALARM COM SW COM
DATA I / O
UNIT CAMERA
+ RX - TX + TX - COM 1 2 3 4 5 6 7 8 COM 9/1 VIDEO INPUT 10/2 11/3 12/4 13/5 14/6 15/7 16/8 COM AUTO ALARM COM SW COM
VIDEO INPUT
1 2 3 4 5 6 7
VIDEO OUTPUT
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7
ON
VIDEO OUTPUT
(example showing camera ID as "05")
P R O T
"DUPLEX" should
be displayed.
Time lapse VCR
REC STOP/EJECT REC
CHECK VIDEO CASSETTE RECORDER
PAUSE/
REVERSE STILL PLAY
REW FF
VIDEO IN
MONITOR
OUTPUT 2
SERIAL-1 SERIAL-2
MONITOR MONITOR
OUTPUT OUTPUT
8
MONITOR MONITOR
OUTPUT OUTPUT
MONITOR
1 2
OUTPUT 1
8
Page 14)
MONITOR screen
O C O L : D U P L E X
The number shown in the
□□ part of ID-□□
should be correct.
MONITOR
SR-L910
OPERATE
OPE. LOCK
COUNT/ SHIFT/TRACKING RESET
CLOCK MENU /CANCEL
TIME TIMER SET/V.LOCK AL/PL
MODE REC RESET
MONITOR
I D - 0 5