Battery Removal - Remington Style Aqua Foil F6 Serie Manual Del Usuario

ENGLISH
Signs that your foil/s and cutter/s need replacing:
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL/CUTTERS
• Press the head release buttons and and pull the head upwards.
• Fit the new head assembly over the hair pocket and press down to click into place.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
1. Pry off the two decorative side panels.
2. Unscrew one screw from the bottom of the shaver and remove the bottom panel.
3. Remove the foil assembly and unscrew the 4 screws underneath it.
4. Remove the two E-rings one on each side of the head then lift off the upper head
assembly.
5. Unscrew the 2 screws below the upper head assemly then lift the rest of the head off
the body.
6. Pry off the upper decorative panel to expose 2 screws. Remove the screws.
7. Remove the front panel to expose 4 screws. Remove the 4 screws then remove the
back housing.
8. Lift out the battery and printed circuit board assembly.
9. Disconnect he battery from the circuit board.
10. Dispose of the battery safely.
RECYCLING
W
6
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.