Bringing Into Use; Assembling / Disassembling The Work Light; Switching The Work Light On / Off; Replacing A Lamp - Hugo Brennenstuhl 0451227 Manual Del Usuario

Safety Instructions / Bringing into use / Maintenance
workbench or working surface. Place the
product down on a non-abrasive surface only.
By doing this you will avoid damaging the
product.
Never operate the product if it has a defective
O
lamp guard . Replace the lamp guard
2
it is defective.
Check the product regularly for damage.
O
Always ensure that there is a minimum clear
O
distance of approx. 50 mm between all sides
of the product and any combustible material.
Always ensure that the product stands in a
O
stable position.

Bringing into use

Q
Assembling / disassembling
q
the work light
WARnInG!
Pull the mains plug out of the
mains socket before you carry out any task on the
device. Otherwise there is a danger to life!
note: To do this you will require a Phillips
screwdriver.
Follow these steps:
1. First place the work light down with its lamp
guard at the bottom on the floor.
2
CAuTIOn! Place a soft cover or similar item
on the supporting surface first to avoid
scratching the lamp guard
2. Push the retainer
light. Ensure that the two clips of the retainer
are seated in the recesses in the work light
(see Fig. A).
3. Now place the spacer
and the work light and screw the stud
8
bolts in clockwise (see Fig. B).
9
4. Push the frame stirrup
. Fix the frame stirrup
4
by turning the stirrup connection screws
clockwise into the predrilled holes (see Fig. C).
5. Place the work light with the stud bolts
the brackets
12
ted the right way around – with the handle
uppermost (see Fig. D).
14 GB
.
2
from below on to the work
8
between the retainer
10
on to both frame legs
1
and legs in place
1 4
. Ensure that the work light is fit-
CAuTIOn! Once the work light is in the
brackets
zontal axis. Ensure that the work light does not
strike the floor with its lamp guard
to observe this advice may result in damage to
if the product.
2
note: Ensure that the mains lead
not become trapped between the work light
and the frame.
6. Turn the adjustment screws with the spacer
sleeves
14
in the frame legs
note: The tighter you screw in the adjustment
screws with spacer sleeves
to swivel the work light.
7. Screw in the two locking screws
using a Phillips screwdriver (see Figs. F).
8. Insert the plug into an earthed mains socket.
Your work light is now ready for
operation.
note: Retighten all threaded connections regularly.
9. Disassembly of the work light takes place in the
reverse order.
Switching the work light
q
On / OFF
Press the ON / OFF switch
i
the work light to switch it on.
Press the ON / OFF switch
i
the work light to switch it off.
8
Maintenance
Q

Replacing a lamp

q
WARnInG!
mains socket before you carry out any task on the
11
device. Otherwise there is a danger to life!
note: To do this you will require a Phillips
into
9
screwdriver.
5
it can be swivelled about a hori-
12
clockwise into the predrilled holes
(see Fig. E).
4
, the harder it is
14
13
on the back of
6
on the back of
6
Pull the mains plug out of the
. Failure
2
does
3
clockwise