SOFTRIDE 26247 Instrucciones De Instalación página 2

DURA RACK INSTRUCTIONS
Assembly Of Rack
Begin assembly of rack by loading the carriage
1
bolts into the 4 holes in the top plate. Place the
top plate on the floor, top side down.
Position the main rack assembly on the top
2
plate, aligning the mounting holes of the top
plate with the holes in the brackets on the main
assembly.
Be sure the cable lock can be accessed from the
3
rear after the top plate has been secured. Place
the lock washers and lock nuts on the carriage
bolts and tighten them to 12 foot pounds.
To convert your 2" rack to a 1.25" rack you will
4
need to add on the 1.25" assembly to the 2"
hitch bar. Remove the nut holder from the inside
of the 2" hitch bar assembly. Slide the three-
holed nut plate inside the 2" hitch bar, aligning
the holes. Pass the three bolts through the lock
washer and 1.25" hitch bar and tighten to the
nut plate. Make sure the three bolts are tight-
ened securely and recheck the tightness of the
bolts from time to time.
Place the straps on the bike arms.
5
FOUR CARRIAGE BOLTS
FOUR WASHERS
1
2-3
FOUR
NUTS
4
5
2