Power Source; Inserting The Batteries - Dörr DAF-44wi Manual De Instrucciones

Power Source

The DÖRR DAF-44 Wi is operated by 4x 1,5V AA alkaline batteries. Alternatively, you can use
rechargeable NiMH or Li-Ion batteries of the same size. Note: Rechargeable NiMH and Li-Ion
batteries are more economical and environment friendlier than conventional batteries.
Hints for using Batteries
• Before inserting the batteries into the device, ensure that both contacts of the batteries
and the flash are clean.
• Ensure to always use 4 batteries of the same capacity, manufacturer and of the same type
(AA).
• Never mix batteries and NiMH rechargeable batteries.
• Remove the batteries from the flash when not in use for a longer time period.
• Batteries develop their full power at approx. 20°C. To ensure full power in cold weather as
well, you should protect the flash from coldness (e.g. keep it close to your body).
• Do not throw batteries into open fire. Risk of explosion! Only recharge batteries which are
designed for this purpose (NiMH rechargeable batteries). Risk of explosion
• Used batteries should not be thrown away with domestic waste but should be returned to a
spezialing shop or any other appropriate facility to ensure an environment-friendly disposal.

Inserting the Batteries

• Open the battery cover by sliding it in the direction of the arrow and swing it open. The
power switch must be in OFF position now.
• Insert 4 AA batteries into the compartment. Please refer to the +/- signs in the battery
compartment for correct polarity.
• Close the battery cover and slide it in opposite direction of the arrow.
• Move the power switch to ON. If the batteries are properly inserted, information will appear
on the LC display and the flash ready indicator will light up after a few seconds. You can
now fire a test flash by pushing down the READY/TEST button.
Automatic Power Saving
To conserve the batteries, the DÖRR DAF-44 Wi flash features an automatic power saving
mode. This mode automatically activates approx. 3 minutes after the flash has not been in use.
However, the flash needs to be mounted onto a camera with TTL flash control to activate this
mode. The flash is in stand-by mode now the the display shows OFF. To re-activate the flash,
press the camera's shutter slightly. The flash is now ready to shoot again. Should you plan not
to use the flash for a longer time period, set the power switch to OFF.
Mounting and Removing the Flash from Camera
Before mounting the flash unit onto your camera, make sure that the power switch is turned
OFF. The camera´s built-in flash must be shut.
Models Canon, Nikon, Pentax, Olympus-Panasonic: Loosen the locking ring and slide the flash
unit's foot onto the camera´s flash shoe. Now tighten the flash with the locking ring. To remove
the flash from the camera, loosen the locking ring again and tear the flash off the camera's
flash shoe.
Model Sony: Make sure that the PUSH button is in normal
state (see sketch). Slide the flash unit onto the camera´s
flash shoe until it locks into place. In order to remove the
flash unit from the camera, press the PUSH button. Now the
flash can easily be removed from the camera. Press the
PUSH button back to normal position.
Display of Flash Range
The DÖRR DAF-44 Wi is micro computer controlled. It calculates the requested flash range
automatically and displays it on the LCD as a bar below the distance scale. The following
factors influence the flash range:
• Focal length in use
• Selected film speed
• Selected aperture
1
2
11