Flo 79510 Manual De Instrucciones página 18

GB
It is required to remove the plug of the charger from the mains socket.
Remove the battery from the charging dock, pressing the battery lock button.
Attention! If after the charger has been connected to the mains the green diode and all the diodes of the load indicator go on, the
battery is fully charged. In such cases the charger will not start loading.
Plug the charger into a mains socket.
Unplug the charger from the mains outlet after the charging is finished.
Pull out the battery from the charging station. You should pull out the battery from the charging station immediately after the end of
charging process. Leaving the battery in the mains connected power charging station may result in its irreversible damage..
The charging station and/or the battery may become warm during charging. This is normal. When you are loading the battery in
a high temperature environment the temperature protection in charger can switch on. The charging process is interrupted until
the cooling of electronic systems of station, after that it is automatically resumed. In such conditions, the battery charging time
will be longer.
Additional notes
Declared, total value of vibration was measured using a standard test methods and can be used to compare one tool with another.
Declared, Declared total value of vibration can was used in a preliminary assessment of exposure.
Attention! The vibration emissions when working with the tool can differ from the declared value, depending on how you use the
tool.
Attention! You must specify the security measures to protect the operator, which are based on an assessment of exposure in the
actual conditions of use (including in it all parts of the work cycle, such as, for example, the time when the tool is turned off or
idling and the activation time).
MAINTENANCE AND STORAGE OF THE PRODUCT
Attention! Before starting any operation, which is described below, you should switch off the grass trimmer from its power supply,
The tool, which is mains powered, should be disconnected from the wall outlet, the tool, which are battery operated, should be
disconnect from the battery.
After each use, you should examine your tool condition with particular emphasis on the patency of the ventilation openings.
Check the alignment of all elements of the tool. Any loose connections should be tightened. Check the status of the cutting ele-
ment. The cutting element guard and the spool you should clean of grass debris. If you notice a damage to the cutting element
guard and/or to spool, they must be replaced before further work. It is forbidden to use the trimmer with damaged cutting element
guard and/or damaged spool.
The tool housing should be cleaned with a soft dry cloth. Clean the housing of residual grass, oil, grease and other contaminants.
The tool should be stored in a dry, closed room, disconnected from the power supply.
The tool should be stored in the areas, which are shaded, dry, and equipped with adequate ventilation to prevent condensation.
The place should not be available for bystanders, especially children. During storage the blades should always be protected by
the cover.
O R I G I N A L I N S T R U C T I O N S
18